Thermal energy and new material division

一、Tec
Ultra fine glass cotton spacer,this separator has a porosity of more than 93%,Enough electrolyte can be absorbed by the cell reaction.Even though the glass cotton spacer is absorbed in the electrolyte,it still maintained at about 10% of the pore as a O2 composite channel,O2 from electrode to negative composite,in order to achieve the oxygen cycle,H2O→1/2O2→H2O.The battery can achieve the sealing effect.

二、Advantage
1.The sb Pb Ca grid alloys and high purity raw materials, battery self discharge, 25 DEG C storage for three months, self discharge rate <2.0%; suction fluid volume is very large, suction speed, good water permeability, absorption and keep the battery rated capacity of electrolyte.
2.AGM battery has good charging efficiency, the specific surface area is large, the porosity is high, so long as the electric liquid frequency is lack, it can guarantee that the oxygen generated by the positive electrode can spread to the negative electrode through the separator.
3.The group adopts tight assembly, less resistance (usually 0.2-0.4m), suitable for high current discharge; small aperture, which can effectively prevent the short circuit of the battery.
4.Due to the adoption of lean solution design, gas recombination efficiency higher, more than 98%, so there is no acid mist from escaping; high chemical purity, does not contain any self discharge impurities
5.The initial capacity is high, third cycle period can reach 100% above the rated capacity; acid resistance and good oxidation resistance
6.Have good low temperature discharge performance, low resistance.